two push buttons control 1 servo

I am trying to get my arduino uno r3 to have 2 push buttons control one servo.

I have a photo booth and I want to have 2 buttons on the front of the booth that when pressed, either move the camera up or down by 5 degrees. I have a potentiometer connected to accomplish this for now but I need to have buttons control it. I am a beginner also, so I need to know how to connect the servo and buttons to the arduino board. Thank you!

soccer3564:
I am a beginner also, so I need to know how to connect the servo and buttons to the arduino board. Thank you!

http://bit.ly/1bp3Bwh
http://bit.ly/1bp3H73

Servo test code that might be of use.

//zoomkat servo button test 12-29-2011

#include <Servo.h>
int button1 = 4; //button pin, connect to ground to move servo
int press1 = 0;
int button2 = 5; //button pin, connect to ground to move servo
int press2 = 0;
Servo servo1;

void setup()
{
pinMode(button1, INPUT);
pinMode(button2, INPUT);
servo1.attach(7);
digitalWrite(4, HIGH); //enable pullups to make pin high
digitalWrite(5, HIGH); //enable pullups to make pin high
}

void loop()
{
press1 = digitalRead(button1);
if (press1 == LOW)
{
servo1.write(170);
}

press2 = digitalRead(button2);
if (press2 == LOW)
{
servo1.write(10);
}
}