I am trying to get 2 Nema 17 stepper motors to turn separately. (one continuous, one back and forth)
Would this be a good wire layout for that? (as in the note the two drivers are red A4988, Fritz did not have them)
IF this is a good setup then what would be a good starting code for them in arduino using AccelStepper or MultiStepper?
Pick just one and get it working first with one of your movements and then do the other. Learn what the difference is.
Why do you start a new topic about the same question?
Better wiring diagram, also asking about code, dont wanna keep updating that one.
I wouldn’t be posting this if I didn’t know how to get at least one moving. My problem is I can’t find an answer on good code for 2 motors working independently
Cross-posting is against forum rules for obvious reasons.
It wastes our time, because we have to ask the same questions again.
Leo..
Duplicate topic
