You can always create your own board, especially if it's for a one off. Have a look on Ebay for the equipment, and you`ll find it really cheap.
You`ll need:
Copper Clad Board
Iron on Transfer Paper
Drill
0.8mm Drill bits (ideally get a set of different sizes)
Etchant - ferric chloride or ammonium persulfate which is nicer to use
Plastic tub for etching
You can get the lot for £20 or under.
There are a huge number of guides on the net on making your own PCB's, and also free software that will enable you to do the job (Cadsoft Eagle is the best and has a limited freeware version).