Hi !
I'm afraid i just burnt my mega328...
Everything was working fine, and at tome point, i misplugged the ground somewhere around the left 5v plug...
Now here is what happens :
- When reseting, either via the button or via shorting reset pin on gnd, the L led become a bit brighter, blink, turn off and on again at not-full brightness.
- When i usb-plug the board on my win10 64b pc, as i just did before, i do not hear the sound telling me that i just plugged a usb device. even when resetting.
- I am unable to load sketches, as i was before. I never had to setup anything, it worked out of the box when plugging and installing arduino ide.
Any advice ?
Thanks !
Matt