I need help with some code. I am creating a mini Barrier Gate and would like for the Uno to control the servo motor. I have an IP camera that can provide 5v out. So what i would like to do is when camera sends 5v out i would like to trigger the servo motor to go from position 0 to 90 stay there for 2 seconds then come back down to 0 and wait for the next input of the 5v and loop it all over again.
I am a noob at coding and i am running out of time so I am hoping someone on here can take this on and create some code for me that does the above.
Hi @jonathang88. This forum category is used for paid work. Please clarify whether you are making an offer to pay someone to write the code for you.
If you are only interested in free assistance in doing the project yourself, that is perfectly fine. However, in that case you should continue to use your existing topic where that is happening, as mentioned by @groundFungus:
hey @groundfungus, thanks for your assistance and i am sorry i am new to this forum and did know i could do that, Thanks for the heads up and will link them next time
I was asking for assistance for this but as i mentioned in the original post i am running out of time and would like to offer to pay someone to create this code for me. This project is for work and although i enjoy getting help by the community in my previous post i am just running out of time. I have an expo show next week that i wanted to show case this gate as our LPR camera scans some plates. I would need the code by next tuesday the 22nd. Do you think that would be possible?
OK, then this is the right place. Thanks for the clarification.
I'm only here to help with the moderation of the forum, so I can't answer that question, but I know some of the other forum members monitor this category and may be able to help you out.
