I have the following sketch (see below) on my PC which compiles perfectly. When I upload it to the board however I keep on receiving the "out of sync" error when the wires are hooked. If I upload it and then make the wire config I do not get an error, but also no readings. Can it be my URM is fried…

URM37 v2.3

robtillaart May 6, 2012, 10:05am 4

Have you a datsheet (link?)

Topic		Replies	Views
URM37 V3.2 - Uno R3 (Sync Problem) Sensors	6	4339	May 6, 2021
URM37 3.2 General Guidance	10	6112	May 5, 2021
Problem using 2 URM37 - Ultrasonic sensors Sensors	10	6214	May 6, 2021
urm37 ultrasonic serial reading problem Sensors	7	2042	May 6, 2021
URM37 V3.2 not working Sensors	1	2501	May 6, 2021