Hello! I am new to arduino and I am trying to get this code to work. When I upload it to my arduino(the usb host shiled + leonardo) the mouse gets powered but don't move at all or sometimes it moves with a huge delay. If anyone could help me with getting this code running I would be really grateful! Here's the code:
/*
- USB Mouse pass through. Works at HID report level. HID report is not
- decoded. Tested on Leonardo with Arduino USB host shield, IDE 1.8.5, and
- Logitech Marble trackball/mouse. This is a proof of concept so is not
- guaranteed to work with all USB mice/trackballs.
*/
// USB host mouse from USB Host Shield Library. Install using Library Manager
#include <hidboot.h>
// USB device mouse library included with Arduino IDE 1.8.5
#include <Mouse.h>
// Satisfy the IDE, which needs to see the include statment in the ino too.
#ifdef dobogusinclude
#include <spi4teensy3.h>
#endif
#include <SPI.h>
class MouseRptParser : public MouseReportParser
{
protected:
void Parse(USBHID *hid, bool is_rpt_id, uint8_t len, uint8_t *buf);
};
void MouseRptParser::Parse(USBHID *hid, bool is_rpt_id, uint8_t len, uint8_t *buf)
{
#if 0
// Demo -- Swap left and right buttons on 4 button Kensington trackball
if (len > 0) {
uint8_t button1 = buf[0] & 0x01;
uint8_t button2 = buf[0] & 0x02;
uint8_t button3 = buf[0] & 0x04;
uint8_t button4 = buf[0] & 0x08;
buf[0] = (buf[0] & 0xF0) | (button1 << 1) | (button2 >> 1) |
(button3 << 1) | (button4 >> 1);
}
#endif
// Run parent class method.
MouseReportParser::Parse(hid, is_rpt_id, len, buf);
Serial.print("MouseRptParser::Parse");
// Show USB HID mouse report
for (uint8_t i = 0; i < len ; i++) {
Serial.print(' '); Serial.print(buf[i], HEX);
}
Serial.println();
if (len > 2) {
uint8_t mouseRpt[4];
mouseRpt[0] = buf[0];
mouseRpt[1] = buf[1];
mouseRpt[2] = buf[2];
// If the mouse/trackball has a scroll wheel, send the value
if (len > 3) {
mouseRpt[3] = buf[3];
}
else {
mouseRpt[3] = 0;
}
HID().SendReport(1,mouseRpt,sizeof(mouseRpt));
}
}
USB Usb;
HIDBoot<USB_HID_PROTOCOL_MOUSE> HidMouse(&Usb);
MouseRptParser Prs;
void setup()
{
Serial.begin( 115200 );
uint8_t attempts = 30;
while (!Serial && attempts--) {
delay(100); // Wait for serial port to connect for up to 3 seconds
}
Serial.println("Start");
if (Usb.Init() == -1) {
Serial.println("USB host shield did not start.");
}
delay( 200 );
HidMouse.SetReportParser(0, &Prs);
Mouse.begin();
}
void loop()
{
Usb.Task();
}