Could use some help with a project. I am very new to arduino and programming in general. I have a cell phone app that receives a BLE signal from a radius networks Rad Beacon X2. The phone app and beacon will broadcast/receive both ibeacon/altBeacon protocols. The rad beacon broadcasts with no services (so I am assuming in peripheral mode?) a major and minor value. I would like to be able to use the arduino 101 in place of the Rad Beacon X2, but so far can't figure out what the IDE command would be to establish/broadcast the major and minor value. I just need the arduino beacon to broadcast the major/minor combination continuously. The ability to specify transmit power and advertising rate would also be helpful. Any ideas if this is possible and what the code should look like?