Hi I was wondering if anyone had every integrated the DS18S20 temperature sensor into a matlab GUI.
I am currently trying to do this and I am have slow progress. I have found multiple sets of code for the arduino environment and have been trying to take that and rewrite it for a GUI. I am however not a coder so therefore I am having some trouble.
I have found the libraries to direct MATlab to for onewire
now I am working on converting my arduino code to C++ to plug into the GUI.
If anyone has done this before or could help me convert the code I would greatly appreciate anytime spent.
Thank you for your time,
Kevin
#include <OneWire.h>
int DS18S20_Pin = 2; //DS18S20 Signal pin on digital 2
//Temperature chip i/o
OneWire ds(DS18S20_Pin); // on digital pin 2
void setup(void) {
Serial.begin(9600);
}
void loop(void) {
float temperature = getTemp(); //will take about 750ms to run
Serial.println(temperature);
}
float getTemp(){
//returns the temperature from one DS18S20 in DEG Celsius
byte data[12];
byte addr[8];
if ( !ds.search(addr)) {
//no more sensors on chain, reset search
ds.reset_search();
return -1000;
}
if ( OneWire::crc8( addr, 7) != addr[7]) {
Serial.println("CRC is not valid!");
return -1000;
}
if ( addr[0] != 0x10 && addr[0] != 0x28) {
Serial.print("Device is not recognized");
return -1000;
}
ds.reset();
ds.select(addr);
ds.write(0x44,1); // start conversion, with parasite power on at the end
delay(750); // Wait for temperature conversion to complete
byte present = ds.reset();
ds.select(addr);
ds.write(0xBE); // Read Scratchpad
for (int i = 0; i < 9; i++) { // we need 9 bytes
data[i] = ds.read();
}
ds.reset_search();
byte MSB = data[1];
byte LSB = data[0];
float tempRead = ((MSB << 8) | LSB); //using two's compliment
float TemperatureSum = tempRead / 16;
return TemperatureSum;
}