Using Arduino Zero to program standalone SAMD21G18

Hi Everyone,

I have got a simple breakout board for the SAMD21G18, just the bare minimum to get it up and running (crystal, load capacitors, reset pull-up, filter caps). I just wanted to know if there was any way for me to program this standalone chip using the Arduino Zero. The Zero has the EDebugger chip, so it should be able to do it. I tried looking for resources on how to do this, but could not find any. I would greatly appreciate if anyone can point me in the right direction.

Thanks in advance
-V

See http://forum.arduino.cc/index.php?topic=364358.msg2521277#msg2521277

Thank you very much, I am following those instructions. Will post back with an update