Is it my imagination or are these boards a pain to incorporate into a final project [s-l500.jpg] Especially, noting the Vcc and Ground are on the incoming cable side (along with the 0.1" connections for A and B). It would be easier if Vcc/GND was on the Di/Ro side. Am I looking at this wrong? Is …

Using RS-485 boards in a project

horace May 22, 2018, 7:54pm 6

I have soldered these RS485 shields into breadboards together with Arduino Pros and other components etc

Topic		Replies	Views
RS-485 Board Options Networking, Protocols, and Devices	8	1505	May 6, 2021
IO expansion shield e collegamento RS485 Generale	19	7972	May 7, 2021
Shield for Tx/Rx RS485? Interfacing	5	4657	May 6, 2021
RS485 - Beginners problems wiring up the shield General Guidance	28	7396	May 5, 2021
RS485, libreria modbus e shield DFRobot Generale	1	2019	May 7, 2021