# Using stepper motor kit

**URL:** <https://forum.arduino.cc/t/using-stepper-motor-kit/986689>\
**Category:** General Guidance\
**Created:** [April 29, 2022, 9:22pm UTC](https://forum.arduino.cc/t/using-stepper-motor-kit/986689 "2022-04-29T21:22:56Z")\
**Posts on this page:** 1\
**Showing post:** 3

<div class="post-metadata">

**Author:** ![groundFungus](https://avatars.discourse-cdn.com/v4/letter/g/73ab20/32.png) [@groundFungus](https://forum.arduino.cc/u/groundFungus)\
**Post date:** [April 29, 2022, 9:38pm UTC](https://forum.arduino.cc/t/using-stepper-motor-kit/986689/3 "2022-04-29T21:38:08Z")

</div>

Here is how the CNC shield pins map to the Uno.

![cnc shield Uno pins](https://europe1.discourse-cdn.com/arduino/original/4X/6/3/6/636635d1b9bc3cf6e8c55a5fdbc1ca921813b857.jpeg)

[simple stepper code tutorial.](https://forum.arduino.cc/t/simple-stepper-program/268292)

[Stepper basics.](https://forum.arduino.cc/t/stepper-motor-basics/275223)

**Make sure** that the coil current limits on the stepper drivers are properly set.

The enable pin (Uno pin 8) must pulled be LOW to enable the steppers. Either do it in software or connect the enable pin on the CNC shield to ground.

---

_[View the full topic](https://forum.arduino.cc/t/using-stepper-motor-kit/986689)._
