verification error on freeduino

I have pulled my freeduino from out of the dust (been more than 3 yrs).

I installed everything on a windows 7 now but now when I try to upload a sketch I get the following error :

avrdude: verification error, first mismatch at byte 0x0000
0x0c != 0x00
avrdude: verification error; content mismatch

although everything was uploaded and the sketch is working fine (blinking LED) I wonder why this error happens.

I have a freeduino v1.16 with an atmega 168 chip.

I have the following setup in arduino IDE :

board : arduino dicimiela or duemilanove with atmega 168
programmer : avrisp mkII

Check with the Freeduino supported forum.

Does win7 have the right driver installed for the USB interface? Is that using an FTDI chip?