Hi. I have a project with a Wemos D1 mini and a 4-channel relay module with optocouplers. I only use 3 of the relays in the module, and on startup, two of them are on HIGH, even though I've set them on low in the setup: void setup() { Serial.begin(115200); pinMode(luz_balcon, OUTPUT); pinMode…

Wemos D1 mini pins on HIGH on startup

system Closed May 17, 2022, 11:38am 10

This topic was automatically closed 180 days after the last reply. New replies are no longer allowed.

Topic		Replies	Views
Boot Wemos D1 Français	9	2474	May 6, 2021
WEMOS D1 mini IO pins Networking, Protocols, and Devices	2	9389	May 6, 2021
Pin States Troubleshooting	2	859	May 6, 2021
bootup General Guidance	4	937	May 5, 2021
Use of WEMOS D8 pin (GPIO15) General Guidance	3	6513	May 5, 2021