what to do after my project is complete???

Projects General Guidance
1

i have a completed project and i am looking for a place to give me a price of production in the UK

can anyone point me in the right place of what to do next once i have my project working?

as to continue i need to know how much i am looking at for mass production.
i am in Oxfordshire in the UK

i will need production for the board and case and an RF remote button

2

A lot depends on how many you are going to make. There are many places in the UK that will do small scale production but the numbers may look big to you.
Are you looking for someone physically close to your location?

3

What is your project is about?

4

I read the title and I was going to suggest "Have a small glass of beer to celebrate"

...R

5

Make sure you have it protected as appropriate and then licence it.

Don't you watch Dragons Den? :wink:

6

These people make the Raspberry Pi in the UK.

7

thanks i will try and ask questions above the project is an RF product
and yes i watch dragons den
i have patent pending
i have had a beer lol

and as for pricing i haven't a clue but i need pricing before i can get funding. which i will apply for via Virgin

so for now i am just looking for someone to make the board for now maybe a few for now just to get off the ground this product will sell for £700 per item and the cost to me so far in hardware was about £300 but that was using arduino and adafruit and other boards so i need to make it an all in one system now

8

Also what is the legal side on me using a lot of libraries and shared code from various sites to help me in my venture
theses include
Arduino
Adafruit
and Ciseco

code samples was used from theses sites

9

For the two plastic cases, are you thinking of getting custom designs?

10

You need to look at each individual libiary and see what the conditions are. As this is an RF project you will need some CE testing, is it an intentional emitter? Normally you will only test the pre production prototype, that is something that is identical to what gets put into production.

I think you are not at the pre production prototype stage, are you looking for someone to do that? Because if you are it will not be the same people who will manafacaturer it.