Hey everyone, I have a load cell connected to my Uno as in my attached picture. I am using a 10k resistor which I know is too large but I have to wait until I can get a hold of small resistors. Can anyone tell me if I am connecting it up correctly? Thanks, James [DSC_0080.jpg]

Wheatstone bridge strain gauge and amplifier setup help

Topic		Replies	Views
Help with 3 wire load cell? General Electronics	7	1939	May 6, 2021
How to amplifie half bridge wheatstone load cells(3 wire load cells)? Sensors	3	5435	May 6, 2021
load cell and op amp Sensors	7	13756	May 6, 2021
OPamp Sensors	18	9059	May 6, 2021
Strain Gauge Readings: RobotShop Amplifier for Wheatstone bridges Sensors	5	2899	May 6, 2021