Why is this Wire.begin() command not working?!?!?!?!?!?

So I am trying to get two BT modules to communicate with each other using the Wire.h library btw I have everything configured on both module(they are hc-05 one is master is slave) and so first I need to use Wire.begin() command to get them connected but when I enter the slave address in the parameters i get this error

exit status 1
unable to find numeric literal operator ‘operator"" d3’

here is my code

#include<Wire.h>

void setup() {
// put your setup code here, to run once:
Wire.begin(98d3:32:707dad);
Serial.begin(38400);
}

What the hell is that gibberish you're passing it?

Take a look at the wire reference.

https://www.arduino.cc/en/Reference/Wire

You need to use wire.begin correctly, and then write code to do the initialization (or call a library that does that)

So I am trying to get two BT modules to communicate with each other using the Wire.h library

Why? Normally, they communicate using Serial.