guys yun is wonderfull!
but i wand to set the ips manual not from dhcp
and if bridge support to setup network parameters from code
if someone can helpme
thanks
lios:
guys yun is wonderfull!but i wand to set the ips manual not from dhcp
and if bridge support to setup network parameters from code
if someone can helpme
thanks
Log into the Yun's web interface and set the static parameters for both the WiFi and the Ethernet connection...
Ralf
guid me to menus please because i cand find this
thanks
mmmm....
tha lan ip and the wifi ip is the same, but only one of the 2 interfaces work same time?
i change to static the lan ip an the wifi have the same ip too?
please guys m new to this so i wand some guide
many thanks
lios:
mmmm....tha lan ip and the wifi ip is the same, but only one of the 2 interfaces work same time?
i change to static the lan ip an the wifi have the same ip too?
please guys m new to this so i wand some guide
many thanks
I am away from my Yun so I can't post any screenshots, but I do have set my Yun to two different IP addresses just fine...
Ralf
lios:
guid me to menus please because i cand find this
Log on to arduino.local
Choose 'configure'
Click on 'advanced configuration panel (luci)' up top
Choose Network->Interfaces from the black bar on top
Now choose 'edit' for the interface you want to change
You can now change the 'protocol' from 'DHCP client' to 'static address'