Sorry about the super nooby question. But I got the infamous 'avrdude: stk500_getsync(): not in sync: resp=0x00' error when uploading and I did all of the usual things change serial ports, update drivers, etc.... I seen somewhere if you don't put a wire into the RX pin until after the sketch has u…

Will putting in a wire into the Arduino after the sketch is uploaded damage it?

Topic		Replies	Views
Can you damage your arduino by using Pin 0 and 1? Programming	10	4707	May 5, 2021
What, if I use the "wrong" hardware? IDE 1.x	12	4925	May 5, 2021
Not uploading sketches onto board IDE 1.x	3	1080	May 5, 2021
Precautions and bugs of board General Guidance	4	879	May 5, 2021
Puzzling Problem Uploading to Arduino Uno IDE 1.x	13	6827	May 5, 2021