Will the Arduino Beginners Kit be enough to make my mask?

Projects General Guidance
1

Hey all. I'm making a gas mask for my Halloween costume that I want to have a total of 16 pulsing LEDs (8 of white and 8 of red). What I have made so far is in the image I've posted a link to below:

Imgur

I want the 8 Red LEDs to glow while the 8 White LEDs to dim and vice versa basically in a breathe of time continuously. I'm fairly new to all of this and wanted to first ask if the 'Getting Started with Arduino' kit will have everything I need to accomplish this. Here's the link to the kit but I'll also post the contents of said kit below:

Kit Link: Arduino | Arduino Microcontroller - Maker Shed

Kit Contents:
(1) Arduino UNO
(1) USB Cable
(1) 9V Battery Pack w/DC Plug (requires soldering)
(1) Clear Breadboard
(1) Deluxe Jumper Wires
(2) Red LEDs
(2) Green LEDs
(2) Blue LEDs
(1) RGB LED
(10) 10K Ohm Resistors
(10) 220 Ohm Resistors
(10) 270 Ohm Resistors
(2) Photo Resistors
(2) Momentary Button

I figured I could wire all of the 16 LEDs to the bread board which will run along the sides of the mask/my head and have it and a battery be bundled up back there. A switch would be put somewhere so I can put it on but just getting the mask done is fine by me. If the kit doesn't have everything, what else do I need to get? Any directions to tutorials that may help me accomplish this? Thanks.

2

not sure of your LED count. (8 of white and 8 of red).

your list :
(2) Red LEDs
(2) Green LEDs
(2) Blue LEDs
(1) RGB LED

no white ?
only 3 red ?

if you have two circuits, your UNO will be great. only need two pins.
make sure they are on the pwm out pins