Wire Resistive pressure sensor coding

I’m making a pressure sensor using velostat and conductive thread communicating from one arduino to another using RF24s. What is the coding I should use on the receiver side so that it’s ready to read the force data?

To answer that we need to know the code on the transmitter side. What is the syntax of the transmitted data?

/*
*
*/
int PressurePin = A0
int force;
#include <SPI.h>
#include <nRF24L01.h>
#include <RF24.h>

void setup() {
Serial.begin(9600)
radio.begin();
radio.openWritingPipe(address);
radio.setPALevel RF24_PA_MIN); I
radio.stopListening();
// put your setup code here, to run once:

}

void loop() {
force = analogRead(PressurePin);
Serial.printline(force);
if(force > 500) {
radio.write(LEDpin,High);
}
else{
radio.write (LEDpin,LOW)
}
delay(100);