Hi I am currently working on a project Wireless notice board using gsm and arduino. I have connected all the connections properly but still nothing is shown on led display can anyone help me
Code :
include <LiquidCrystal.h>
LiquidCrystal lcd(7,6,5,4,3,2);
int led=13;
int temp=0,i=0,x=0,k=0;
char str[100],msg[32];
void setup()
{
lcd.begin(16,2);
Serial.begin(9600);
pinMode(led, OUTPUT);
digitalWrite(led, HIGH);
lcd.print("GSM Initilizing...");
gsm_init();
lcd.setCursor(0,0);
lcd.print("Wireless Notice");
lcd.setCursor(0,1);
lcd.print(" Board ");
delay(2000);
lcd.clear();
lcd.print("Circuit Digest");
delay(1000);
lcd.setCursor(0,1);
lcd.print("System Ready");
Serial.println("AT+CNMI=2,2,0,0,0");
delay(500);
Serial.println("AT+CMGF=1");
delay(1000);
digitalWrite(led, LOW);
}
void loop()
{
for(unsigned int t=0;t<60000;t++)
{
serialEvent();
if(temp==1)
{
x=0,k=0,temp=0;
while(x<i)
{
while(str[x]=='#')
{
x++;
while(str[x]!='*')
{
msg[k++]=str[x++];
}
}
x++;
}
msg[k]='\0';
lcd.clear();
lcd.print(msg);
delay(1000);
temp=0;
i=0;
x=0;
k=0;
}
}
lcd.scrollDisplayLeft();
}
void serialEvent()
{
while(Serial.available())
{
char ch=(char)Serial.read();
str[i++]=ch;
if(ch == '*')
{
temp=1;
lcd.clear();
lcd.print("Message Received");
delay(1000);
}
}
}
void gsm_init()
{
lcd.clear();
lcd.print("Finding Module..");
boolean at_flag=1;
while(at_flag)
{
Serial.println("AT");
while(Serial.available()>0)
{
if(Serial.find("OK"))
at_flag=0;
}
delay(1000);
}
lcd.clear();
lcd.print("Module Connected..");
delay(1000);
lcd.clear();
lcd.print("Disabling ECHO");
boolean echo_flag=1;
while(echo_flag)
{
Serial.println("ATE0");
while(Serial.available()>0)
{
if(Serial.find("OK"))
echo_flag=0;
}
delay(1000);
}
lcd.clear();
lcd.print("Echo OFF");
delay(1000);
lcd.clear();
lcd.print("Finding Network..");
boolean net_flag=1;
while(net_flag)
{
Serial.println("AT+CPIN?");
while(Serial.available()>0)
{
if(Serial.find("+CPIN: READY"))
net_flag=0;
}
delay(1000);
}
lcd.clear();
lcd.print("Network Found..");
delay(1000);
lcd.clear();
}