I have setup my module to attach to my Router by doing the instructions. However, It specifically addresses setting the 2 modules to communicate with each other on the DIGI XBIB-U-CAP Development boards Page 14 - 17 by giving the module IP addresses in each window (page 16). This is great if you are doing a mesh point to point. However, I want to use one module with a micro controller (Arduino UNO.) which the manual does not address. So I have programmed the wifi module as suggested in the manual except for setting the module destination ip.
Once I plug it into the Arduino wireless Proto shield I have the switch set to micro so that it communicates with the server program that has been uploaded into the UNO. Next I power it on. If I do a ping from any of my local computers It will ping correctly. If I try to access the webpage that the server program creates then it gives me a page not found message.
Thanks for Asking the questions i appreciate it! Hopefully it will trigger something that will get me see what I am missing....