Awsome response and thank you soo much for taking the time.
Your logical lesson is undeniable. always lol.
I understand all of what you are saying. So you are following me yes your second thought was correct. the relay would be set up some hwhere away from the original transmitter so the relay and the original transmitter can both speak to the drone. More specifically. The relay would be situated as to extend range. As for the gentleman that asked why HC-12. 433Mhz attenuation vs 2.4Ghz attenuation. As for what I do with them. Well I put them in my butt. They make my
dookie transmit data.
Questions I am left with. Thanks to Robin2:
Time based segregation of incoming signals via Arduino code?
Switch the relay on/off based on drones position? Seems interesting. I think I like this idea I believe you mentioned this? Obviously two will have to be sending data to the drone at one point due to the
fact that the original transmitter must remain active. However, once the drone reaches the end of the
transmission range of the original transmitter. Could I then cut on the relay that is now actually closer to the original transmitter then the drone is. My initial thought is perhaps in this orientation the relay will drown out the signals coming from the original transmitter thus making the multiple signals a non-issue.
I am aware there are ways to setup a WIFI intranet However I cannot think of any other ways to setup a wireless web if you will.