Wireless sketch upload to Arduino FIO using XBee

Development Tools IDE 1.x
2

I got it working! 8)
I can now upload sketches wirelessly, using the standard Arduino 1.0.1 IDE and i did not need to update the bootloader on the FIO or anything!
I had to do the following:

  • disable CTS on DIO7 on both XBees
  • on the base unit: change setting "DIO Change Detect" to 08 instead of FF. This means only pin 3 is monitored for changes instead of all 8 pins.

I didn't try each one individually so can say if both are required. :slight_smile:
Thanks to King7 for his post on Nate's tutorial.