To Pylon , thanks for helping me out !
Hurra it works !
Here is what I did to make it work. Hope it will be useful for others trying the same
After removing some "old" versions and cleaning up and a fresh installation of Arduino sw 1.0.5 compilation of programs worked successfully using UIPEthernet.
Here is the wiring that worked , only 6 wires
VCC – 3.3V
GND – GND
SCK – Pin 13
SO – Pin 12
SI – Pin 11
CS – Pin 10
Next test was to compile Echoserver in the UIPEthernet example folder.
Uploaded successfully.
Started a Dos box (Command prompt ) on my XP box
C:\telnet 192.168.2 16 1000 // I modified the example to match my current network setup at home. Yours may be different.
Connection established and I could type in letters and numbers and have them "echoed" back and also see them on the
terminal monitor.
regards,
Nils