Xbee SPI Mode

Hello,

I’m trying to configure my Xbee shields to SPI mode. I have S1 editions, so I don’t need to flash any special firmware, although what I’m lacking now is the physical interface between my computer and the Xbee chips. I have a breakout board to make this a bit more convenient, and a USB cable I’m willing to tear apart, although what I’m lacking now is exact knowledge about which pins on the Xbee need to be connected to which wires on the USB cable. Any advice would be well received! Thanks.

XBees have an SPI mode?

did you mean API?

http://code.google.com/p/xbee-api/