I am trying to set up a Jaycar XC4411 board. I have downloaded all the drivers and test software. I have followed the instructions in the Jaycar "troubleshooting guide".
All goes well ,I think, But after uploading code to both processors and set switches to connect nothing happens.
The "guide" states to open your wireless internet and you should see a new wireless network. no such thing happens.
What have I dine wrong??
Have you talked to JAYCAR ?
Maybe somebody has one of those here but your chances of an answer would be better from them if it is not truly an Arduino.
Could you also take a few moments to Learn How To Use The Forum.
Other general help and troubleshooting advice can be found here.
It will help you get the best out of the forum in the future.
This topic was automatically closed 120 days after the last reply. New replies are no longer allowed.