Wise list,
I tried to configure the xport, but got no response from the Terminal after I press the x key.
I used the arduino wire hack (like this http://ladyada.net/images/eshield/wirehackarduino.jpg) for configuration. But after I reset the xport (reset pin to Ground) and press x key in Terminal, I didn't get any response.
I'm not sure what's wrong. Do I need to type anything in Terminal before I press the x key? What I did is I just open the terminal, and press the x key when reseting xport.
Any one has ideas? All i wanna do is configuration 
Thanks a lot!
Elim