Ok i tried to use 4k7 and 2k2 and copletly take away both resistors from SDO - so the one that was connected to same path leading to UNO pin 12 (2k2) and also the one that was after this one connected to ground (4k7) is that right?
The problem seems to be still there. So I tried to add one 4k7 resistor between pin 7 and T_CS (in the diagram its without any resistor at all) and the continous refresh with random coordinates x,y,z semms to stop now... at lest I hope its not one of the time its behave OK and it will not start to act like crazy again
EDIT: ok seems to be a moment when it gets crazy again but itss till so far way more better than it was.
But there is strill one huge problem - the x,y coordinates are off or broken because 3 draw six rectangles in two rows, there are 3 in one row, so 3 and 3 under them. I tried to get the position from the first one - from top left corner and bottom right corner. I got 2928/2225 vs 3784/784 but when i try to get tge coordinates now, i get way different walues like 4094/1704 vs 4094/4094 and then I got 4094/4094 almost on whole place around as many time as I touch.... and still no corner of display is 0/0 .....