Automatic Dog Door wtih cam without collar

Today, I wound a coil onto the rectangular wooden frame. Leaving it in place, it was easy to nudge turns of wire slightly apart, making small changes to the inductance (<2uH). The highest voltage observed across the coil was 48.3V RMS. After disconnecting from the circuit, this optimum coil had an inductance of 92.3uH.

With this 300x400mm coil, a "25 mm diameter coin card" was detected at a maximum height of 390mm above the coil center.

Attempting to adjust the total inductance of this rectangular coil by adding bobbin-core inductors in series and/or parallel only resulted in lower total voltages across the coil / bobbin-core set.

The manufacturer's coil showed an inductance of 105.7uH. Connected to the module, the voltage was measured at 41.1V RMS. The 25mm RF "coin card" was defected at a maximum of 170mm above the center of the coil.

The loops of this coil were fixed in place, and I did not attempt to adjust them. Instead, I added various combinations of bobbin-core inductors in parallel to the coil and observed the results.

As the total inductance of the system decreased, the voltage across the whole set increased, up to a point. Eventually, at even lower inductance, the voltage began to fall.

This increase in observed voltage was accompanied with an increase in maximum detection height.


Possibly the most important finding here is that a manufacturer supplied coil may not be properly tuned for maximum performance.