[Beginner] Using a Flex Sensor

No, it's not.

The thing that's a bit harder is the translation between schematic and breadboard wiring. The breadboard image makes you able to plug the wires where they belong, but it doesn't make you understand how a circuit actually works.

For understanding what a circuit is really doing, a schematic diagram is much easier to read, as it clearly shows what components actually are and how they're connected.

Hello all, I'm working on this same schematic and sketch, I have it working perfectly, however, I want to be able to out put a different angle than what is being read, specifically if the sensor is completely flat it should output 180 degrees, all the way to 0 when it's completely bent. How would I go about altering the code to do this?

Use the map() function.