Getting output voltage from load cell in arduino

[snchew]

My load cell is working perfectly. Thank you for your advice!

[snchew]

Thank you for everyone's help and advice. I have managed to read the output signals from my load cell with my Arduino Uno board.

For anyone who is looking for help with a similar project, here is a diagram of my set up with the type of op amp I used:

const int loadCellPin = A0;

int value = 0;

float volt = 0.0;

float force = 0.0; 

void setup() {
Serial.begin(9600);
pinMode(A0,INPUT);
}

void loop() {
value = analogRead(loadCellPin);

volt = (value * (10.0/1023.0))* -1; //For compression

force = (-10.177 * volt) - 0.1723;

Serial.print("Value: ");
Serial.println(value);

Serial.print(" ==> voltage: ");
Serial.print(volt);

Serial.print(" \t force: ");
Serial.println(force); 

delay(1000);
}