I want to reset my arduino in every single minute. Can anyone help me with the code???

I thought about doing this at a known time each night to prevent the rollover of micros(); Considering that micros() rolls over after about 70 minutes then, even if there were a problem with it doing so, which there is not, then resetting the Arduino every 24 hours would not be a solution anyway. …

I used this to reset Arduino. void software_Reset() // Restarts program from beginning but does not reset the peripherals and registers { asm volatile (" jmp 0"); }

PaulS: Why do you think you need to reset the Arduino every minute? OldSteve: I'd also be interested in hearing why you'd want to do that. Perhaps OP managed to install Windows on his Arduino?

bunny_1994: I want to reset my arduino in every single minute. Can anyone help me with the code??? You can use a hardware solution, but as mentioned:

Perhaps OP managed to install Windows on his Arduino? :slightly_frowning_face:

Sorry I meant millis() working on ping code and have been typing micros() a lot :slight_smile: millis(): Returns the number of milliseconds since the Arduino board began running the current program. This number will overflow (go back to zero), after approximately 50 days. and this is unrelated to…

There is no problem with millis() rollover if you write your code correctly and hence, no need to reset the Arduino. Please post the code that is causing you a problem.

Bad millis(). >:( Gammon Forum : Electronics : Microprocessors : millis() overflow ... a bad... Gammon Forum : Electronics : Microprocessors : millis() overflow ... a bad thing?

Like said befor, the roll over is NOT a problem. Just keep the Arduino running. As long as you use millis() in the way of blink without delay aka if (currentMillis - previousMillis >= interval) { you never have a problem. Not after a day, not after 50 days, not after a year.

Actually I'm stuck in my heart rate monitoring project. Need help. I'm using Arduino uno,Pulse sensor amped module.

How to reset arduino via code?

Projects Programming

system April 26, 2016, 10:30am 18

JimboZA:
Guessing it's this....

Ah. Complete clueless-ness. I see.

Topic		Replies	Views
Millis() in an Arduino 24/7 General Guidance	8	103	November 2, 2025
Resetting an arduino through code [SOLVED] General Guidance	5	1796	September 17, 2024
Reset arduino with code Troubleshooting	16	295247	May 6, 2021
Using reset pin and millis() how i reset Mega board every 1 hour interval Programming	15	1576	May 5, 2021
Can a Mega reset pin be controlled with code? Programming	44	2225	January 15, 2024

How to reset arduino via code?

Related topics