Hi I am new to Arduino, and I decided to make a drone using a arduino as a Flight Controller. I know that this should not have been mine first project, but I am in too deep now. I am using: ELRS 2.4GHz NANO ExpressLRS Receiver BETAFPV NANO 2400 RX Radiomaster Pocket Arduino Nano 33 BLE How do I …

Hi, My solution to the problem was using the CRSF library to read the receiver. HOWEVER keep in mind that you need a arduino with a chip that can run the library. There is a list attached to the library when you download it/ find it on GitHub. Personally I used the arduino nano esp32, because to my…

do I have to flash the receiver in this case?

I have managed to flash and bind the receiver to the transmitter. Does anyone know what code to run so that I can read the data from the receiver. For now at least read one channel. Also I am coding in the Arduino IDE

Hello, I have an ELRS receiver that is connected to a transmitter, but I cant figure out how to program the Arduino Uno to read, and interpret the output of the radio. I also don't know how to connect it to the Arduino. The receiver only has RX and TX output. Thank you in advance

I tried to use code like this: void setup() { // Initialize serial communication at 115200 baud rate Serial.begin(115200); // Print a message indicating successful connection Serial.println("ELRS Receiver Connected at 115200 baud!"); } void loop() { // Check if data is available from …

Serial.read() reads data from the Serial Monitor in the IDE. Your code should be printing only what you type into the input box on Serial monitor. ...unless you have connected this radio thing to the same pins that Serial Monitor uses. You should not do that because those pins are not available for…

I have the TX pin of the receiver connected to the RX pin on the arduino (pin 0)

Your two topics seem to have the same subject. If so, please, refrain from doing this. [image] How to use ELRS reciever with arduino and an ELRS radio Robotics I have a ELRS 2.4GHz NANO ExpressLRS Receiver BETAFPV NANO 2400 RX and a Arduino Uno. I have no idea how to con…

Your two topics seem to have the same subject. Please, refrain from doing this. [image] How to use ELRS reciever? Robotics Hello, I have an ELRS receiver that is connected to a transmitter, but I cant figure out how to program the Arduino Uno to read, and interpret the o…

How to use ELRS Receiver with Arduino?

Other Hardware Robotics

Topic		Replies	Views
Bridge Custom USB/HID vers ExpressLRS (CRSF) Français	8	190	April 8, 2026
No info from RP3 ExpressLRS 2.4 GHz receiver Networking, Protocols, and Devices	2	274	January 31, 2025
New to arduino RF 433mhz tx and rx question General Guidance	25	644	April 27, 2026
Help needed: PS4 Controller (Bluepad32) → ESP32 → nRF24L01 RC system Programming	6	213	May 1, 2026
ELRS CRSF arduino telemetry Networking, Protocols, and Devices	0	1552	December 20, 2023

How to use ELRS Receiver with Arduino?

Related topics