Ltc6915 parallel control program compilation

[nzmxp]

I did some research and found codes to adapt

using single button to toggle states and writing and reading to eprom

I have a project that uses a single momentary button to toggle between different modes. I have the change/state working well thanks to some ingenious code posted by That1guy99 (thank you). Now I'm trying to store the current mode's value in the Arduino's eeprom (so when Arduino powers down then up again it will be in the same mode). When I run the program, I get double digits of the same mode value - i.e. instead of 3, I get 33 using the serial monitor. I can figure out why? is there something t…

and

How to Store a Momentary Button Press As a Menu Selection