Change of address of train using DCC
I am implementing a DCC system using Arduino, designing my own software. Programming a train to run is OK, but how do I change the manufacture's address for the train? The default address is 3, can a member let me know where the spec is to change the address? What packet format is needed to do this?
Thanks in advance
Robert
(deleted)
Bobsbees:
can a member let me know where the spec is to change the address? What packet format is needed to do this?
This is not an Arduino problem.
...R
When I googled I found the packet structure for communicating with a train and issuing commands to stop, start etc, but not how to change the address of the train.
Bobsbees:
When I googled I found the packet structure for communicating with a train and issuing commands to stop, start etc, but not how to change the address of the train.
Sounds like you need to extend your Googling.
How about posting the link to what you have found?
...R