What's up, so i have finally fined tuned most things but I've been stuck on this last part. How do i make it so that the toggle switch whenever it's flipped from A to B the servo changes regardless of what angle it is. Currently whenever it's flipped from A to B it works but to make the servo move a…

It is incumbent on you to ask questions on the work that has been done for you in this thread. You will only learn this stuff when you ask questions on the things you do not understand. As a summary, this sketch demonstrates the use of non-blocking TIMERs. These TIMERs makes your sketch respons…

This is a way too generalised question to give an answer. Software that does what?

You can neatly draw a schematic with pencil on paper.

Your code has two places with servo.write(servoAngle); lastServoAngle = servoAngle; I think is this a bad idea

Your complete code does more than just react on the toggle-switch. You should give a detailed description of what your code shall do all in all there is a IR-remote and there is a light-sensor Your description of your wanted functionality should define ALL situations that can happen. At least a…

[image] How to provide an easy to read schematic and how not Tutorials This tutorial shall show how to provide an easy to read schematic of your wiring and how you should not post fritzing pictures don't post frizzy-pictures like that! if you look at this pic…

[image] kxngdavid: Currently whenever it's flipped from A to B it works but to make the servo move again i have to move it A to B then back to A then to B. Move the flippy-bit out of the reading==LOW conditional. [image] kxngdavid: if ((millis() - lastDebounceTime) > debounceDelay) { …

[image] DaveX: but that would be sloppy LOL. I've written all kindsa of bad code, but no one ever called it sloppy. a7

another question: a toggle-switch as I understand it works this way let's assume at first switch is in position closed which pulls down => the IO-pin-state = LOW first pressing down of toggle-switch => switch changes to opened => IO-pin-state = HIGH toggle switch can be released and stays in po…

[image] kxngdavid: I want it to be that if i flip the toggle switch, no matter where the servo is it will go to the opposite angle 0 or 180. [image] gcjr: and the angle simply set to 180 if LOW and zero when HIGH? ???

Toggle switch state

Projects Programming

StefanL38 September 20, 2024, 8:12pm 13

Topic		Replies	Views
Can't figure out how to control servo with IR remote General Guidance	60	901	December 31, 2025
IR Remote & Servo Motor General Guidance	84	1442	September 27, 2024
Stepper motor, tmc 2209, 6 switches (speed and full rotations) Programming	151	1582	March 23, 2026
Servo mit einem Taster auf 2 Positionen stellen Deutsch	65	1088	February 23, 2026
Need help with toggle switching a servo in "for" loop Programming	19	328	December 25, 2024

Toggle switch state

Related topics