Hello,
thank you for all your replies!
The sync cord I am taliking about is "a cable with a standardised coaxial PC (for Prontor/Compur) 3.5 mm (1/8") connector[1] (as defined in ISO 519[2])" (from: Flash synchronization - Wikipedia).
I am not an expert at all about electronics so I don't know wheter it is electronically isolated from the camera or not or what are the volt specifications.
After a longer research last night on this forum I found this topic (Control Arduino with Canon Camera - Project Guidance - Arduino Forum) where someone talked about PC cords and Arduino.
User Bjhund said:
"The trigger pin on the canon flash is 5 volt to ground.
I guess the camera hot shoe is optoisolated from the camera sinse there is never a voltage on the shoe. only resistance (4-5 ohm).
So, i connected my camera to the arduino, and found out that the shoe is "high" all the time the camera takes a picture." then continues: "A Not all time 5v. it is all time connected while taking pict. It works like a switch."
Somebody, instead of using directly the PC socket on the camera, used something like this to get the signal from the hotshoe mount: https://www.amazon.it/TF-334-Adattatore-hot-shoe-connessione-fotocamere/dp/B01LQ24CTA/ref=sr_1_2?__mk_it_IT=ÅMÅŽÕÑ&keywords=hot+shoe+to+pc+sync&qid=1578645030&sr=8-2
Would it work the same?
So, apparently it is possible to do it, my questions are...
- How do I connect the PC Sync cable to Arduino?
I guess I would need to cut one end of the cable and I expect there are two cables inside that must be connected one to a PIN one to GND? - Is there a risk of damaging the camera doing so?
- I read somewhere that people where using something called INTERRUPT to read the signal (I guess is something similar to what is normally used for rotary encoders), is it correct? How should it work? Sorry I tried to read online but it is still a bit unclear to me...
Thank you very much for your precious help!
My very best,
Alessandro
PS: I thought of triggering the camera with Arduino but for the convenience of how I should use this thing I really need to use the camera trigger. Thanks for the idea!