Upload error when using NANO board made by LAFVIN

Development Tools IDE 1.x
1

I ordered a 3-pack of NANO boards from LAFVIN. When I try to upload a sketch the IDE says "Problem uploading to board". Nothing seems to work.. below are my settings in "tools" drop down.

Tool settings in IDE:
Board > Arduino Nano
Processor > ATmega328P (Old Bootloader)
Port > COM4

IDE snapshot error.PNG
IDE snapshot error.PNG1920×1042 46.9 KB

2

Please do this:

  • (In the Arduino IDE) File > Preferences
  • Uncheck the checkbox next to "Show verbose output during: compilation"
  • Check the checkbox next to "Show verbose output during: upload
  • Click "OK"
  • Sketch > Upload
  • After the upload fails, you'll see a button on the right side of the orange bar "Copy error messages" (or the icon that looks like two pieces of paper at the top right corner of the black console window in the Arduino Web Editor). Click that button.
  • In a forum reply here, click on the reply field.
  • Click the </> button on the forum toolbar. This will add the forum's code tags markup to your reply.
  • Press "Ctrl + V". This will paste the upload output between the code tags.
  • Move the cursor outside of the code tags before you add any additional text to your reply.