32 AWG Wire Connection

[LarryD]

Some ideas:

Share tips you have come across

You can make durable jumper cables for your solderless breadboard by using heat shrink instead of a Dupont housing. The heat shrink acts as a strain relief. Clear heat shrink lets you see the condition of the M/F connector. [A.jpg] [B.jpg] [C.jpg]

---

Share tips you have come across

A wire splice is a reasonable solution to connect a large gauge wire to DuPont pin connectors. If you need a higher current connection, use two DuPont pins. The reverse is also true; a 30 AWG sensor wire can be spliced to a more reasonable 22/24 AWG wire. [A.jpg] Works the other way too, smaller to larger: [image]

---

Share tips you have come across

PCB Eyelets Used as Wire Ferrules PCB eyelets crimped on stranded wires keeps those strands under control. This process makes wire connections easier and less likely to result in fabrication problems. The Following images show the technique: [A] [B] [C] [D] [E] [F] [G] [H] [I] [J] EDIT When stripping insulation from wires, highly recommend using an insulation displacement type wire stripper: [image] [image]

---

Share tips you have come across

28 AWG DIY ferrules for screw terminals In another post, a user asked how to terminate 28 AWG wire in a screw type terminal strip. @6v6gt suggested to use a Dupont crimp connector to act as homemade ferrule. Below shows how this process can be accomplished. Add heat shrink to act as a strain relief. The colour of this heat shrink can identify the terminal number to use: Yellow would be terminal #4 Brown and Yellow would be #14, etc. [A] [B] [C] [D] [E] [F]

---

Crimping Dupont cables.

3ee2dd7711bd7c7ae07838b46b296b43c6a070c7.pdf