Arduino ir, my first project!

Forum 2005-2010 (read only) General Exhibition
1

Hello i made an remote controlled Arduino device!
Controlling some Led's With an universal Remote Control!

Imgur

/* 5 Channel ir remote control
Created by Asghar Furqan
A fully open-sourse program!

circuit:
ir module connected to pin 2(Digital)
led 1-2-3-4-5 connected to pin 3-4-5-6-7
*/

#include <IRremote.h>

int RECV_PIN = 2;
int led1 = 7;
int led2 = 3;
int led3 = 4;
int led4 = 5;
int led5 = 6;

IRrecv irrecv(RECV_PIN);

decode_results results;

void setup()
{
Serial.begin(9600);
irrecv.enableIRIn(); // Start the ir receiver
pinMode(led1, OUTPUT);
pinMode(led2, OUTPUT);
pinMode(led3, OUTPUT);
pinMode(led4, OUTPUT);
pinMode(led5, OUTPUT);
}

void loop() {

if (irrecv.decode(&results)) {
Serial.println(results.value, DEC);

if(results.value == 16705559) //if you want to configure with your remote controll change the results.value
digitalWrite(led1, HIGH); // set the LED on
if (irrecv.decode(&results)) {
Serial.println(results.value, DEC);
if(results.value == 16656599)
digitalWrite(led1, LOW); // set the LED off

irrecv.resume(); // Receive the next value

if(results.value == 16672919)
digitalWrite(led2, HIGH); // set the LED on
if(results.value == 16697399)
digitalWrite(led2, LOW); // set the LED off

irrecv.resume(); // Receive the next value

if(results.value == 16689239)
digitalWrite(led3, HIGH); // set the LED on
if(results.value == 16664759)
digitalWrite(led3, LOW); // set the LED off

irrecv.resume(); // Receive the next value

if(results.value == 16668839)
digitalWrite(led4, HIGH); // set the LED on
if(results.value == 16676999)
digitalWrite(led4, LOW); // set the LED off

irrecv.resume(); // Receive the next value

if(results.value == 16674959)
digitalWrite(led5, HIGH); // set the LED on
if(results.value == 16650479)
digitalWrite(led5, LOW); // set the LED off

irrecv.resume(); // Receive the next value

}

}
}