Atmel Flip "Could not open USB device"

Using Arduino Microcontrollers
1

I have an Arduino Uno R3, with the ATMEGA328P ic and when using the Atmel Flip and trying to connect it I get the error "Could not open USB device", I don't know what to do.

If you know anything it would help me a lot.
Thank you

2

Explain what you have tried, give a link to the instructions you followed, and post a photo of your UNO please.

3

Hi, I'm trying to make a joystick with the Arduino, and the code from GitHub - AlanChatham/UnoJoy: UnoJoy! allows you to easily turn an Arduino Uno (or Mega or Leonardo) into a PS3-compatible USB game controller

And a couple of tutorials (in Spanish)

As well as Flip 3.4.7.

But it gives me this error. I don't have much experience in Arduino.

image
image614×516 23.5 KB

4

Spanish is not my language so a 13 minute video is no help to me.

Please give the steps that you took like

  1. Wired the reset pin to ground on the 6-pin header next to the 16U2.
  2. Connect the board and started flip.
  3. Etcetera.

Note that I'm not familiar with the procedure.

There is a Spanish section on the forum if you rather have support in your native language; I can move your topic there if you prefer that.

Does your Uno indeed have the 16U2?

5

Yes, move me if you think it would be better. And if you have the module. But he still doesn't go.

Greetings and thank you

6

This topic was automatically closed 180 days after the last reply. New replies are no longer allowed.