Connecting an ethernet module to arduino uno

Good morning,

I've bought ENC28J60 Ethernet LAN Network Module from ebay (http://www.ebay.com/itm/260920486422) and found a library written for ENC28J60. My problem is I could not find a connection instructions between arduino board and the module.

I've wol, so, si, sck, cs, reset, clkout, and int pins on the module. Can anyone tell me which digital outputs should connected to ethernet module pins?

Thanks, Tuncay

SO is 12, SI is 11, SCK is 13, CS is 10, INT is 2, RESET is RESET (or another digital pin if you wanna control the reset). The rest (WOL, CLKOUT) are not needed in most situations.

While it is "a work in progress"... there are some notes on these matters at...

http://sheepdogguides.com/arduino/art5serv.htm

pylon: SO is 12, SI is 11, SCK is 13, CS is 10, INT is 2, RESET is RESET (or another digital pin if you wanna control the reset). The rest (WOL, CLKOUT) are not needed in most situations.

Thanks for the instruction, it worked. I can ping the arduino board when I started any webserver example. But when I try to open the ip address on browser it goes to "timeout" page and ping screen says "destination unreachable"

I'll look for another library and examples. Thanks for your help.