I want to control a servo motor, not a ClearPath motor, using a ClearCore Industrial I/O and Motion Controller on the Arduino IDE. However, as a beginner, I'm unsure about the wiring and programming. I would appreciate it if experienced individuals could share their knowledge on this matter.
Hello 123tony_tony-tony
Welcome to the best Arduino forum ever.
Take a search engine of your choice and ask the WWW for 'servo +arduino tutorial' to collect some data to be sorted out to get the needed information.
Contact Teknik and ask them how to wire it. Once you have it running and can control it using their test tool, then come back here.