DFRobot 10 DOF Mems IMU Sensor

Other Hardware General Electronics
1

Hi everyone,
Im just looking for a bit of help... Im doing a project that uses the DFRobot 10 DOF Mems IMU Sensor and im very new to arduino so im a bit confused. The sensor has a accelerometer, gyroscope , compass and a pressure sensor all on the one board. Im trying to figure out what code i would use so that i only get the X and Y axis as an output.... Any advice.

Thanks

2

First one I picked after Googling was this page.

Documents field.
Arduino libraries and Sample codes.
Leo..