Hey, I have the elegoo smart robot car v3.0 kit assembled. when i try to upload any sketch to it. It gives me an Avrdude Stk500_getsync(): Not in Sync Resp=0x30 Error. i am on win 10 with latest drivers. i have tried removing any pins going into rx0 and it uploads successfully but does not react to the remote provided. Please assist. am i going wrong with the baud rate ? heres the link to the robot car manual
Welcome
Please post your code; just in case, do not forget the code tags (see How to get the best out of this forum).
Please post the relevant schematic (or wiring) that you use; it should be somewhere in the zip that you provided.
Did you connect them back afterwards?
So this question is not about upload problems 
Your topic has been moved to a more suitable location on the forum.
This topic was automatically closed 180 days after the last reply. New replies are no longer allowed.