Error occurred while uploading sketch(timeout)

[omethma]

Sketch uses 662 bytes (0%) of program storage space. Maximum is 253952 bytes.
Global variables use 9 bytes (0%) of dynamic memory, leaving 8183 bytes for local variables. Maximum is 8192 bytes.
avrdude: ser_open(): can't open device "\.\COM4": The system cannot find the file specified.

avrdude: ser_drain(): read error: The handle is invalid.

avrdude: ser_send(): write error: sorry no info avail
avrdude: stk500_send(): failed to send command to serial port
avrdude: ser_recv(): read error: The handle is invalid.

avrdude: stk500v2_ReceiveMessage(): timeout
avrdude: ser_send(): write error: sorry no info avail
avrdude: stk500_send(): failed to send command to serial port
avrdude: ser_recv(): read error: The handle is invalid.

avrdude: stk500v2_ReceiveMessage(): timeout
avrdude: ser_send(): write error: sorry no info avail
avrdude: stk500_send(): failed to send command to serial port
avrdude: ser_recv(): read error: The handle is invalid.

avrdude: stk500v2_ReceiveMessage(): timeout
avrdude: ser_send(): write error: sorry no info avail
avrdude: stk500_send(): failed to send command to serial port
avrdude: ser_recv(): read error: The handle is invalid.

avrdude: stk500v2_ReceiveMessage(): timeout
avrdude: ser_send(): write error: sorry no info avail
avrdude: stk500_send(): failed to send command to serial port
avrdude: ser_recv(): read error: The handle is invalid.

avrdude: stk500v2_ReceiveMessage(): timeout
avrdude: ser_send(): write error: sorry no info avail
avrdude: stk500_send(): failed to send command to serial port
avrdude: ser_recv(): read error: The handle is invalid.

avrdude: stk500v2_ReceiveMessage(): timeout
avrdude: stk500v2_getsync(): timeout communicating with programmer
Failed uploading: uploading error: exit status 1

[UKHeliBob]

Welcome to the forum

Your topic has been moved to a more relevent category of the forum

[omethma]

please help me to solve this error

[ptillisch]

Hi @omethma. This error might be caused by having the wrong port selected from the Tools > Port menu in Arduino IDE.

Please perform this experiment to verify that the port you have selected is your Arduino board:

With official boards, the port will be labeled with the board name in the menu (e.g., "COM42 (Arduino Uno)"). In this case, you can be fairly confident that you have identified the port. Select that port from the menu and try uploading again.

With some cheap derivative boards the port will not be labeled. You can positively identify the port using this procedure:

1. Disconnect the USB cable of the Arduino board from your computer.
2. Select Tools > Port from the Arduino IDE menus.
3. Take note of the ports, if any, listed in the menu.
4. Close the Tools menu.
   The ports list is only updated when the Tools menu is re-opened, so this step is essential.
5. Connect the Arduino board to your computer with a USB cable.
6. Select Tools > Port from the Arduino IDE menus. - If a new port is listed in the menu, that is the port of your Arduino board.

Select that port from the menu and try uploading again.

If the upload still fails, or if no new port appeared after you plugged the Arduino board into your computer, add a reply here to let us know and we'll investigate the problem further.

[omethma]

thanks for your reply ; but there is same error