Hi All,
i just purchased Arduino Mega and Ethernet shield for my new project (Facility management system) and i want to know if i can connect it on board without any change or that i need to change\ configure the legs in different way ?
If you have an Arduino Mega2560 and an original Arduino Ethernet Shield Rev. 6 you can just stack the later on the first and you're fine. If that's not your configuration, post it.
Yes, both boards are original Arduino This is my configuration but the version on both boards are V3
You probably mean release 3 which is identical to revision 6 of the schematics to my knowledge. This release should have the 6-pin ICSP header on the bottom side between the reset button and the SD card slot. If you have that you're fine. The shield works with the Mega2560 without modifications.
ok, thank you very much