MKR Ethernet Shield booting problem when ethernet cable is connected : MKR 1010

Hello guys,

We have the same issue as descried here :

We use just Ethernet shield (Ethernet cable connected) with MKR1010 WiFi with Blink sketch flashed. Two sets of HW we have got have this issue.

It seems it is HW issue and to be carefully handled on Arduino side (some issue with ).

Not sure that could be right solution (msg from original thread):

I have contacted Arduino support, and they told me to short between vin & 5v, tested and it worked.
thank you all

Arduino team , please advise.

Thanks,
iotbotscom

This topic was automatically closed 120 days after the last reply. New replies are no longer allowed.